Home › Common Problems › Garage Door Panel Damage
Garage Door Panel Damage
in Frisco, TX
Frisco sits right in North Texas hail country. Severe hailstorms hit the area multiple times a year, and quarter-sized or larger hail will dent steel garage door panels on impact. Add in the common fender-bender in the driveway, and panel damage is one of the most frequent calls we get in this area. A dented panel does not always mean the door stops working, but it can warp the section enough to pull the door off its track over time.
Quick Answer
Damaged garage door panels in Frisco are usually caused by vehicle impact or hail. A dented panel may still work but it can break the door's seal, let in heat, and reduce the door's structural strength. Single-panel replacement is sometimes possible if the line is still made. If not, a full door replacement is the practical answer. Get it looked at before the damage spreads to the track.
Telltale Signs
Warning Signs to Watch For
- Visible dents, creases, or punctures in one or more door sections
- The door section looks bowed outward or inward when viewed from the side
- Light is visible around the edges of a panel when the door is closed
- The door makes a new noise when that section passes through the track
- The door sticks briefly at the same spot every time it opens or closes
- Hail-pattern dimpling across multiple panels after a storm
Root Causes
What Causes Garage Door Panel Damage?
Hail impact from North Texas storms
The Dallas-Fort Worth area, including Frisco, sits in one of the most active hail corridors in the country. Hailstones larger than an inch will dent standard 25-gauge steel panels. A single storm can damage every section of a door facing the street.
The Fix
Panel Replacement or Full Door Replacement
If the damaged sections are still in production, a technician can swap individual panels. If the door model is discontinued or more than half the panels are damaged, full replacement is the cleaner fix.
Vehicle impact in the driveway
In neighborhoods like Stonebriar and Starwood where three-car garages are common, vehicles back out of tight bays multiple times daily. A slow bump into the bottom panel creases the steel and can push the bottom section out of alignment with the section above it.
The Fix
Bottom Section Replacement and Track Check
The technician replaces the damaged bottom section and inspects the track for any bending caused by the impact. If the track is bent, it is straightened or replaced before the new panel goes in.
Self-Diagnosis
Which Cause Applies to You?
Check the signs you're observing to narrow down the likely root cause before your inspection.
| What You're Seeing | Hail impact from North Texas storms | Vehicle impact in the driveway |
|---|---|---|
| Small round dimples spread across the entire door surface | ||
| One large horizontal crease across the bottom section only | ||
| Damage matches a recent hailstorm that hit nearby streets | ||
| Door sticks at the same damaged section every cycle | ||
| Dent is limited to the bottom panel and one side is lower |
Free Inspection
Get a Diagnosis in Frisco
An on-site inspection is the only way to confirm which cause applies to your property. Free, no obligation.
(806) 491-5721Free on-site inspection
Written estimate before work starts
Serving Frisco & surrounding areas
Other Problems
Services That Fix This
Also Helpful